Lippert Components In Wall Slide-Out System - Manual (Page 4)

Status led’s - 2 led’s, 1 green and 1 red, are provided to indicate current controller status and faults.
Motor direction switches - Used to change direction of motors, 2 are provided, 1 for each motor.
Mode button - Places controller in manual mode, for jogging individual motors. Places controller
in calibration mode, where stall current can be increased or decreased or returns controller to auto
mode.
Power source - 12 volt dc input. Unit will operate from 8 volts dc to 18 volts dc.
Motor 1 connector - Power and encoder input for motor 1.
Direction switch connector - Provides input from customer supplied extend and retract switch.
Stall calibration - Allows for adjustment of stall force.
Motor 2 connector - Power and encoder input for motor 2.
1-6 Manual mode -Jog
Press mode button 2 times quickly, press a 3 rd time and hold for approximately 5 seconds. The green
led will flash on and off. Manual mode now active for motor #1. Using the extend and retract switch,
motor 1 can be jogged manually.
Press the mode button 1 more time and the green led will flash on and off. Manual mode is now
switched to motor #2. The extend and retract switch will now jog motor #2.
When both motors have been jogged to the desired position, exit manual mode by pressing and
holding the mode button until both red and green led’s start to flash. The control is now back in auto
mode.
1-6. 2 Units with the C1 board “electronic” manual override.
In the event of any fault code, the unit can be manually overridden electronically using these steps:
1. Locate the circuit board
2. Press the “mode button” six times quickly, press a 7th time and hold for approximately 5
seconds.
3. The red and green LED lights will begin to flash indicating you are in override mode
4. Using the wall switch, press and hold the “in” button until the unit comes completely in.
status led’s motor direction switches mode button power connection
motor 1 connector motor 2 connector direction switch stall calibration
4