Lippert Components Tent Camper Bike Rack - Manual (Page 8)

8
Fig. 19
Fig. 20
Fig. 21
Safety Strap
To install Safety Strap, layout
strap completely across the top
of the unit. (Fig. 19) Center the
strap side to side as closely as
possible.
Measure the bicycles to be
mounted from the front axle to
the rear axle. Measure out the
same distance on the unit from
the Front Fork Axle Assembly
towards the rear of the unit.
Set Safety Strap in that loca-
tion, parallel to the Tent Camper
bike Rack Crossbar.
(Fig. 20)
The Safety Strap will layover the side
of the unit as seen in Fig. 20. On the
frame of the unit, using at least a 3/8”
no larger than a 1/2” Tek Screw, mount
the “D” Rings on both sides of the unit,
Fig. 21. The ends of Safety Strap will
hook onto these “D” Rings allowing
the Safety Strap to be cinched down.
Strap should be snug but not tight.
For any questions regarding Service, Warranty or Installation, contact:
Lippert Components, Inc.
Service and Warranty - Plant #39
2703 College Ave.
Goshen, IN 46528
(866) 524-7821
NOTE: If the Safety Strap contacts a
furnace or water heater vent, be sure
to remove strap prior to using appliance.
Failure to remove strap may result in damage to unit or property, serious
physical injury or death.