Longshine COBRA15 - Manual (Page 29)

COBRA15
29 Version: 1.0
Please follow the instructions below to change memory on COBRA15.
1. Make sure that the terminal and all other peripherals which are connected to the terminal
have been powered down and unplugged.
2. Disconnect all power cords and cables.
3. Locate the SO-DIMM socket on the system board.
NOTE the key on the socket. The key ensures the module can be plugged into the socket in only
one direction.
5. Grasping the module by its edges, align the module into the socket at an approximately 30
degrees on the socket. The contact fingers on the edge of the module will almost completely
disappear inside the socket.