Connecting the power supply cable, Connecting a power supply cable, Setting the bios configuration jumper – Longshine D410PT User Manual
Page 37
Advertising
Installing and Replacing Desktop Board Components
37
Setting the BIOS Configuration Jumper
NOTE
Always turn off the power and unplug the power cord from the computer before
changing a jumper. Moving the jumper with the power on may result in unreliable
computer operation.
Figure 13 shows the location of the Desktop Board’s BIOS configuration jumper block.
Figure 13. BIOS Configuration Jumper Block
The three-pin BIOS jumper block enables board operating modes. Table 11 shows the
jumper settings for each of the available modes.
Advertising