Longshine LCS-8131N3 - Manual (Page 16)

WLAN GENERAL
16
Note:
This example is an open wireless network. If you are going to connect to an AP with security protection, you
will have to configure the encryption settings in this profile to be corresponding to your AP. Please click on
the “Network Authentication” drop list to select an authentication method, and then select a “Data en-
cryption” type. Fill in each required blanks and click “OK”.
Introduction to the Wireless LAN Utility
Note: This management instruction uses Windows XP as the presumed operation system. Some functions
are not supported in Windows 98se or Windows ME.
Starting the Wireless LAN Utility
Double click the shortcut on your desktop. The Wireless LAN Utility pops up.
You may click on the tabs above to configure this adapter. The checkboxes below provide the following
functions:
Show Tray Icon
Check this checkbox to show the utility icon on your system
tray, which is in the notification area at the lower-right corner
of the windows desktop. You may also uncheck it to remove
the utility icon from system tray.
Windows Zero Config
Uncheck this checkbox to use native Windows XP wireless
support (Wireless Zero Configuration Service) instead of us-
ing this utility to configure your wireless network.
Radio Off
Check this checkbox to prevent this adapter form transmitting
or receiving signals. Uncheck it to communicate.
Disable Adapter
Check this checkbox to disable this wireless adapter. Un-
check it to enable this adapter again.