Longshine LCS-C842MT - Manual (Page 8)

10/100Base-TX to 100Base-FX Converter
- 6 -
Switch Setting
DIP 1 – Enables / disables auto-negotiation
DIP 2 – Copper port (RJ45) duplex mode: full or half –duplex
DIP 3 – Copper port (RJ45) data bit rate: 10Mbps or 100Mbps
DIP 4 – Fiber port duplex mode: full-duplex or half-duplex
DIP 5 – Enables / disables Link Fault Signaling (LFS)
DIP 6 – Enables / disables Local Loop Back (LL BK)
DIP 7 – Enables / disables Remote Loop Back (RLBK)
Important:
In order to configure switches 2, 3 and 4, switch 1 (auto-
negotiation) must firstly be disables
Notes:
•
Setting the duplex mode is feasible while the media
converter is“on-line”.
•
All models in this series feature the above set of DIP
swiches.