Longshine LCS-FS9116-B - Manual (Page 3)

1
Introduction
The device is a powerful, high-performance Fast Ethernet switch,
with all 16 ports capable of 10 or 100Mbps auto-negotiation
operation (NWay), which means the switch could automatically
negotiate with the connected partners on the network speed and
duplex mode. It is ideal for micro-segmenting large networks into
smaller, connected subnets for improved performance, enabling the
bandwidth demanding multimedia and imaging applications.
Moreover, the 10/100Mbps auto-sensing ability provides an easy
way to migrate 10Mbps to 100Mbps network with no pain.
Compared to the shared 10Mbps or 100Mbps networks, the switch
delivers a dedicated 10/100Mbps connection to every attached
client with no bandwidth congestion issue. This switch also supports
auto MDI / MDI-X function. Each port could be used to connect to
another switch or hub with no crossover RJ-45 cable.
Store-and-forward switching mode promises the low latency plus
eliminates all the network errors, including runt and CRC error
packets. To work under full-duplex mode, transmission and
reception of the frames can occur simultaneously without causing
collisions as well as double the network bandwidth.
The switch is plug-n-play without any software to configure and also
fully compliant with all kinds of network protocols. Moreover, the rich
diagnostic LEDs on the front-panel can provide the operating status
of individual port and whole system.
Before you start to install the switch, check the following contents in
this package：
One NWay switch
One Power cord
User’s manual
Rack-mount brackets and screws
(Rack-mount " brackets are optional available for non 19" models)