Longshine LCS-GS9120 - Manual (Page 6)

6
Desktop Installation
1. Attach the provided robber feet to the bottom of the
switch to keep the switch from slipping. The
recommend position has been square-marked.
2. Install the switch on a level surface that can support
the weight of the unit and the relevant components.
3. Plug the switch with the female end of the provided
power cord and plug the male end to the power outlet.
Rack-mount Installation
Rack mounting facilitate to an orderly installation when
series of networking devices being installed. The switch is
supplied with rack mounting brackets and screws for rack
mounting the unit.
Procedures to Rack-Mount the Switch in the rack:
1. Disconnect all the cables from the switch before
continuing.
2. Place the unit the right way up on a hard, flat surface
with the front facing you.
3. Locate a mounting bracket over the mounting holes on
one side of the unit.
4. Insert the screws and fully tighten with a suitable
screwdriver.
5. Repeat the two previous steps for the other side of the
unit.
6. Insert the unit into the rack and secure with suitable
screws (optional).
7. Reconnect all the cables.