Longshine LCS-K602-A - Manual (Page 11)

10
4.3 Auto-Scan Function
Hot Key:
[Scroll] [Scroll] [S] [Esc] to BEGIN.
There is about 10 seconds for the initial time waiting.
Press the [Esc] key to STOP.
NOTE : [Esc] will stop the
atuo-scan operation and make
the KMV jump to the current
scanning PC.
You can activate the Auto-Scan function by using the following two-step Hot Key
sequence. To send commands to the KVM Switch, press the [Scroll] key twice
(Step 1), then press [S] (Step 2). When you press the Auto-Scan hot key sequence,
the KVM Switch alternates between the two PCs and displays them on the
monitor.
Each PC is display one of time interval from 5 ~ 60 seconds (The interval is
adjustable) before switching to the next. When you press any key on the keyboard,
the Auto-Scan will stop and the monitor screen will jump back to the original PC.
During the Auto-Scan mode, the KVM will ignore the mouse operation, if you move
mouse you will not see the cursor move on the screen.
Adjustable scan time interval setting ( 5 ~ 60 sec. )
Hot-key: Pressing the <Scroll >, <Scroll > then <S> and < n>
*n = 1~ 9
<n> Scan time
interval
<n> Scan time
interval
1 5 6 30
2 10 7 35
3 15 8 40
4 20 9 60
5 25