Cuisinart HSM-70 - Manual (Page 4)

ASSEMBLy
1 . Attach hand mixer to stand
Line up the indent on the back end of the
hand mixer with the tab in the back of
the stand . Place hand mixer on the stand
with tab in indent and push the front of
the hand mixer down onto the stand until
it clicks into place .
2 . Remove hand mixer from stand
Push down on hand mixer release button
and lift the front end of the mixer off and
up from the stand .
3 . Raise stand head
Push down head lift release lever and
raise stand head until it locks into place .
4 . Lower stand head
Push down on head and fully lower the
stand head until it clicks into place .
5 . To place bowl on base
Line up grooves under bowl with the
grooves on the base and it locks into
place .
USE AND CARE
Inserting Beaters
1 . Unplug mixer and set the power switch
to the OFF position .
2 . Insert beater with collar into the larger
hole . Push beater in until it clicks into
place . Insert the beater with the plastic
padding on the end into the smaller hole .
Push beater in until it clicks into place .
Inserting Dough Hooks
1 . Unplug mixer and set the power switch
to the OFF position .
2 . Insert dough hook with collar into the
larger hole . Push dough hook in until it
clicks into place . Insert the dough hook
without the collar into the smaller hole .
Push dough hook in until it clicks into
place .
Note:
Dough hook with collar will also have plastic
padding on the end of the dough hook .
Inserting Chef's Whisk
1 . Unplug mixer and set the power switch
to the OFF position
2 . Hold chef’s whisk at stem end, and
insert into smaller hole . Push whisk in
until it clicks . DO NOT PUSH WHISK
IN FROM WIRE END, AS YOU MAY
DAMAGE WIRES .
Turning Mixer On/Off
Plug mixer into outlet . Press On/Off switch
to turn mixer On . Mixer will immediately
begin to mix on Speed 1 . To turn mixer off,
press On/Off switch again .
Changing Speeds
Press the + button on the digital touchpad
to increase the speed . Press the - button to
decrease the speed .
CLEANINg AND
MAINTENANCE
1 . Unplug your Cuisinart ® Hand Mixer
before cleaning .
Hand Mixer
Release hand mixer from stand by pressing
the hand mixer release button . Then lift the
beater release lever and remove the beaters
from the mixer . Wipe the hand mixer with a
damp cloth or sponge . Do not use abrasive
cleaners, which could scratch the surface .
NEVER PUT THE MOTOR HOUSING IN
WATER OR OTHER LIQUID TO CLEAN .
Bowl
If hand mixer is not on the stand, lift bowl
from base . If hand mixer is on stand, raise
the stand head using the head-lift release
lever and then remove bowl from base .
Wash the bowl by hand and dry thoroughly
or put in dishwasher . Never use a wire
brush, steel wool or bleach .
Stand
Wipe with a damp cloth and dry . Never use
abrasives or immerse in water .
Turntable
NOTE: It is not recommended to take turn-
table off stand . To clean, remove bowl and
hand mixer from stand . Wipe down turn-
table or wash by hand .
4
Larger
Hole