Maxim Integrated MAX31782 - Manual (Page 17)

  MaximIntegrated 2-13
MAX31782 User’s Guide
Revision 0; 8/11
2.6.2WatchdogTimerReset
The watchdog timer is a programmable hardware timer that can be used to reset the processor in case a software
lockup or other unrecoverable error occurs . Once the watchdog is enabled, software must reset the watchdog timer
periodically . If the processor does not reset the watchdog timer before it elapses, the watchdog can initiate a reset .
If the watchdog resets the processor, the MAX31782 remains in reset and holds the RST pin low for 12 clock cycles .
When a reset occurs due to a watchdog timeout, the watchdog timer reset flag (WTRF) in the WDCN register is set to
indicate the source of the reset .
2.6.3ExternalReset
During normal operation, the MAX31782 is placed into external reset when the RST pin is held at logic 0 for at least four
clock cycles . Once the MAX31782 enters reset mode, it remains in reset as long as the RST pin is held at logic 0 . After
the RST pin returns to logic 1, the processor exits reset within 12 clock cycles .
An external reset pulse on the RST pin can also bring the MAX31782 out of its low-power stop mode . When this occurs,
the MAX31782 resets and returns to normal CPU mode operation within 10 clock cycles .
2.6.4InternalSystemResets
There are two possible sources of internal system resets . An internal reset holds the MAX31782 in reset mode for 12
clock cycles .
1) When data BBh is written to the special I
2 C slave address 34h .
2) When in-system programming is complete and the ROD bit is set to 1 .
Figure 2-6. MAX31782 State Diagram
POR
SYSTEM CLOCK
STARTUP DELAY
t SU:MOSC
PORT6 GPIO INT, I 2 C
START INT, SVM INT
OR EXT RESET
CKCN.STOP = 1
V DD > V BO
V DD < V BO
V DD < V BO
V DD < V BO
BROWNOUT STATE
CPU DISABLED
ANALOG ACTIVE
CPU MODE
DIGITAL CORE ON
ANALOG ON
CODE IS EXECUTING
STOP MODE
DIGITAL CORE OFF
ANALOG ON
SVM MONITOR DEPENDS
ON SVMEN AND SVMSTOP