Maxim Integrated 78M6631 Evaluation Board - Manual (Page 17)

UM_6631_077 78M6631 Evaluation Board User Manual
Rev 1 17
2.7 Verify Serial Connection to the PC
After connecting the USB cable from the 78M6631 Evaluation Board to the host PC, start the
HyperTerminal application (or another suitable communication program) and create a session using the
communication parameters shown in Table 1.
Table 12: COM Port Setup Parameters
Setup Parameter 78M6631
Port speed (baud) 38400
Data bits 8
Parity None
Stop bits 1
Flow control None
HyperTerminal can be found in Windows by selecting Start All Programs Accessories 
Communications HyperTerminal. The connection parameters are configured by selecting File 
Properties. The New Connection Properties menu appears.
Select the appropriate COM port and click Configure. The COMn Properties menu appears.
Note that port parameters can only be adjusted when the connection is not active. It may be necessary to
click the Disconnect Button to disconnect the port.
Select
COM Port