Maxim Integrated 78M6610+LMU Evaluation Kit - Manual (Page 8)

78M6610+LMU Evaluation Kit User Manual
8 Rev 1
3.1.1 Jumper and Switch Descriptions
The following tables describe the default position of the EV board jumpers and switches for using the on-board
shunt current sensor at sensor slot S1.
J23 Jumper Description
J23 Pins Description Jumper
1/2 Connect J15 SHUNT to 78M6610+LMU Sensor Slot 1 Installed
2/3 Connect J10 CT2+ to 78M6610+LMU Sensor Slot 1 -
J24 Jumper Description
J24 Pins Description Jumper
1/2 Connects J8 SHUNT to 78M6610+LMU Sensor Slot 1 Installed
2/3 Connects J10 CT2- to 78M6610+LMU Sensor Slot 1 -
J9 Jumper Description
J9 Pins Description Jumper
1/2 Connect AC Neutral to V3P3A (chip reference) Installed
3.1.2 Device Configuration
Use the Configuration tab to map the sensors as shown in the table below. Re-enter the gain value, as
needed, for the shunt resistor into the S1_GAIN register.
Voltage Current
VA S0 0 IA S1 0
VB IB
VC Pre-Amp 1X S1