Operating instructions – Chicago Electric 65414 User Manual

Page 10

Advertising
background image

Page 10

for technical questions, please call 1-800-444-3353.

SKU 65414

opERATing insTRucTions

Read the EnTiRE iMpoRTAnT

sAfETY infoRMATion

section at the beginning of this

manual including all text under

subheadings therein before set

up or use of this product.

To pREvEnT

sERious injuRY:

operate only with proper

spark arrestor installed.

operation of this equipment

may create sparks that can

start fires around dry

vegetation.

A spark arrestor may be

required.

The operator should contact

local fire agencies for laws or

regulations relating to fire

prevention requirements.

starting the Engine

inspect engine and equipment

looking for damaged, loose,

and missing parts before

set up and starting. if any

problems are found, do not use

equipment until fixed properly.

Before starting, first familiarize

yourself with proper shut down

and emergency shut down

procedures.

checking and filling Engine oil
cAuTion!
Your Warranty is VOID if the

engine’s crankcase is not properly

filled with oil before each use. Before

each use, check the oil level. Do not

run the engine with low or no engine

oil. Running the engine with no or

low engine oil WILL permanently

damage the engine.

check the oil

level with the engine stopped and

in a level position.
Wipe dipstick exterior with a clean

1.

cloth. Remove the dipstick and wipe

it off with a clean rag. Pour engine oil

into the oil fill hole until the level of oil

is even with the bottom edge of the

oil fill hole (if you cannot see the oil

through the oil fill hole, then the oil is

too low and more oil must be added).
Reinsert the dipstick into the oil

2.

filler neck, but do not screw in, then

remove it to check the oil level. The

oil level should reach the upper limit

(H) mark on the dipstick (bottom edge

of the oil fill hole).
If the oil level is not to the upper limit

3.

mark (bottom edge of the oil fill hole),

add the appropriate type of oil until

the oil level reaches the upper limit

mark.

This gEnERAToR hAs An AuTo-shuTDoWn

oil sEnsoR. if EnginE sTops oR Will

noT sTART, chEcK oil lEvEl.

Engine Oil SAE 10W-30 above 32°F

SAE 5W-30 at 32°F or below

Replace the Oil Dipstick.

4.

The Oil Sensor will automatically

shut down the engine before the oil

level falls below the safe/low limit.

To avoid nuisance tripping of the

Oil Sensor and damage to property,

check that the oil level is at the

Advertising