MF Digital DirectorEC OP OptiEC Printer - Manual (Page 14)

Page 14
Aligning the MF Digital OptiEC Printer
(fig. 3)
Alert:
Before starting the Alignment Utility,
position the front end of the printer on the
dotted line on the top of the drive bay.
1. From your Start Menu Open the EC Alignment
Utility (fig. 1). It will be located in the folder
designated when you installed the alignment
utility. Select OptiEC printer type. Click on
Start Test.
2.
Follow the instructions by opening the OptiEC
printer tray, and Clicking Yes (fig. 2). The
picker arm will hover a disc over the printer
tray, observe the discs position and make the
adjustments to the printer (fig. 3).
3.
Click Yes when you are satisfied with your
adjustment (fig. 4).
4. The picker arm will then place the disc onto
the printer tray. Follow the on screen
instructions and click OK (fig. 5).
5. Once you are satisfied with the printer tray
alignment, tighten the thumb-screws located
on both sides of the printer.
(fig 1)
(fig 2)
(fig. 4)
(fig. 5)