MF Digital ScribeEC 3000 Series - Manual (Page 2)

Aligning the Drive Bay
1. 3704EC & 3706EC ONLY – SKIP IF SETTING UP 3702EC AS DRIVE BAY IS
PRE-ALIGNED AT FACTORY
Please follow the instructions below to align the drive bay on the
Scribe EC Standalone.
• From the main operating screen depicted below:
• Press the “4” key. You will then be prompted to “Start Loader
Test Mode?”. Press the “Start/Yes” key to enter “Loader Test
Mode”
•
The following screen will appear. Place a CD in the 1 st input area.
•
To align the drive tower, first press the number with corresponds
to the “C” command for calibrate. Then press “I” for input. This
will pick up a CD from the input area and place the CD in the
drive. Inspect the placement of the CD and align the drive tower
accordingly.
•
After inserting a CD, press “A” for accept, and the arm will pick
the CD out of the drive and place on the output spindle.
•
Repeat process as necessary until you are satisfied with the
alignment of the drive bay.