Microtel DialStat (No Fault Indicators) User Manual
Page 15
MICROTEL
DialStat
TM
11
Individual Channel Alarm Messages:
z Enter **c1 to record an alarm message for a specific I/O channel. (c = 1 to 4 for
the I/O channel of interest). The dialer will respond “Ready”.
z Speak your message clearly into the handset.
z The dialer will speak back the message after the 6-second recording interval
z Repeat procedure for the next I/O channel and message.
9. Verify Configuration Data is Saved in the Dialer.
Turn OFF the Dialer’s power switch, wait a few seconds, then turn it ON again.
Verify configuration data has not changed. By entering *00 and listening to the
spoken status report.
NOTE: It is a good idea to test the dialer calling ALL telephone numbers successfully
during an alarm condition when commissioning. This is especially true when dialing
complex numbers such as pagers, that may contain pauses and wait for answer
sequences. When dialing a pager, manually do it and listen to approximate the delay
after the pager terminal answers.