Microtel Series 200 - Manual (Page 18)

1. ENTER, DELAY, 0 [intercall delay, ready]
2. Enter a two digit number corresponding to the desired number of hours of
delay
[the intercall delay is xx hours]
(Numbers less than 10 must be entered with a 0, as in 01, 05, etc.)
To read this data,
1. READ, DELAY, 0
[the intercall delay is xx hours]
5.
Delay Run Programming
The Run Mode may be entered after a programmable delay. To do so,
1. Depress DELAY, RUN
[system delay, ready] 2. Enter the desired two digit delay in minutes (01 to 99
minutes)
[the system delay is xx minutes]
(Values less than 10 minutes must be entered with a preceding 0, i.e. 01, 07...)
The flashing Run indicator verifies that the system is in the delayed run mode. After
the delay is completed, the system will enter the Run Mode and the Run indicator will
stay on.
14