Microtel Series 250 - Manual (Page 17)

dialing mode, confirm with the telephone company that services the installation that the
line to which the unit is connected to will accept tone dialing.
1.
ENTER, MODE, 0
[indicator will flash]
2.
Enter “0” for pulse type dialing, or “1” for tone type dialing.
To verify the dialing mode, cause the system to test dial by selecting
1. READ, No.(1, 2, 3, 4, 5, 6, 7 or 8)
[telephone number will be dialed]
3. Message Repetitions
The system will repeat its fault status message a number of times in the course of any
telephone call which it places. The system is shipped programmed to repeat the
message 8 times during each call. If it is necessary to change the number of times the
message if repeated, perform the following programming steps.
1. ENTER, #
2. Enter a two digit number corresponding to the desired number of message
repetitions (01 to 99).
To verify this data, test dial a number and listen to the number of message repetitions
before the system terminates the call attempt.
4. Intercall
Delay
When a call placed by the system is acknowledged, (see section III.C for the
acknowledgment procedure) it will delay further calls for a programmable period to allow
time for the condition to be corrected. The time delay period following an acknowledged
call is called the intercall delay. The unit is shipped with this delay set to 1 hour. It may
be from 1 to 99 hours and is programmed at the system keyboard as follows.
1. ENTER, DELAY, 0
[indicator will flash]
2. Enter a two digit number corresponding to the desired number of hours of
delay.
(Values less than 10 hours must be entered with a leading 0,
Example: 01= one hour)
13