MIDI Solutions Event Processor Plus - Manual (Page 3)

Thank you for purchasing the MIDI Solutions Event Processor Plus.
The MIDI Solutions Event Processor Plus offers 32 settings, each of which can be programmed to perform a different
MIDI processing function. The Event Processor Plus is MIDI-powered and requires no batteries or power supply to
operate.
INTRODUCTION
To program the Event Processor Plus connect the MIDI Out from your MIDI interface to the MIDI of the Event
Processor Plus. The MIDI can be left disconnected during programming.
Once the Event Processor Plus is programmed, it can be inserted wherever it is required in your MIDI setup. Connect
the MIDI Out or Thru of the sending device to the MIDI
of the Event Processor Plus, and the MIDI of the Event
Processor Plus to the MIDI In of the receiving MIDI device. It is recommended that the number of MIDI Solutions
products powered by a single MIDI Out or Thru be limited to four.
The Event Processor Plus offers 32 settings, each of which can be programmed with a unique MIDI processing
function. The Event Processor Plus is programmed by sending it MIDI System Exclusive programming commands
from a computer with a MIDI interface. These commands are described in detail on the MIDI Solutions website,
however
(see
www.midisolutions.com/support.htm).
Upon receipt of a programming command, the Event Processor Plus's MIDI indicator LED flashes rapidly for about
one second to indicate that the setting has been stored. Settings are retained after power is removed, and the unit
can then be inserted wherever it is required in your MIDI setup.
The Event Processor Plus's MIDI Indicator LED will light as soon as the sending device is turned on, and flashes
whenever MIDI data passes through the unit. Each MIDI event received is compared with each of the Event
Processor Plus's 32 settings, beginning with setting #1.
All unprocessed MIDI events are sent unchanged to the MIDI Out.
In
Out
In Out
the Programming Tools software creates these commands automatically
If a MIDI event matches a setting, the event is processed
according to that setting.
CONNECTIONS
PROGRAMMING
OPERATION
3
Receiving Device
MIDI In
Sending Device
MIDI Out or Thru
MIDI Solutions TM
Made in Canada
MIDI
In Out
Processor
Event
Processor
Plus
MIDI Indicator LED