MIDI Solutions Velocity Converter - Manual (Page 4)

CLEAR SETTINGS
DUMP SETTINGS
CURVE ASSIGN
USER CURVE
To clear all of the Velocity Converter's settings, send it the following System Exclusive programming command:
It is recommended to send the Clear Settings command to the Velocity Converter prior to programming the unit to
ensure that all previous settings are cleared.
To dump all of the Velocity Converter's current settings, send it the following System Exclusive message:
Upon receipt of this command the Velocity Converter will dump its current settings to the MIDI Out.
To assign a velocity curve to a particular MIDI channel, send the Velocity Converter the following System Exclusive
programming command:
All bytes must be in Hexadecimal format (see hexadecimal conversion table at end)
= curve# (see charts on following pages), set = 00 to specify user curve
= MIDI channel (see MIDI channel table at end)
To program the Velocity Converter to apply curve #11 to all incoming velocities on channel 1, set = 0B for curve
#11 and set = 00 for channel 1. These values result in the following System Exclusive programming command:
F0 00 00 50 09 01 F7
To program the user curve, first send the Velocity Converter the following System Exclusive programming command:
Upon receipt of this command the LED will flash rapidly, indicating that the user curve values are expected in the form
of Note or Controller data. The first 127 Note or Controller values received after this are stored sequentially as the
user curve (corresponding to input velocities 1 through 127).
To program the Velocity Converter to assign a velocity of 1 to all input velocities under 30 and a velocity of 64 to all
other input velocities, send F0 00 00 50 09 02 F7 followed by 29 Note or Controller messages with value 1, followed
by 98 Note or Controller messages with value 64.
F0 00 00 50 09 00 F7
F0 00 00 50 09 10 F7
F0 00 00 50 09 01 aa cc F7
aa aa
cc
Example
aa
cc
0B 00
F0 00 00 50 09 02 F7
Example
PROGRAMMING COMMANDS
4