Warning, Assembly instructions, Cc4090 only – Cub Cadet CC4090 User Manual

Page 8

Advertising
background image

8

ASSEMBLY INSTRUCTIONS

ADJUST THE D-HANDLE

The CC4075 uses a D-handle, which is pre-installed on
the unit. If you ever need to adjust it, make sure it is at
least 6 inches from the end of the shaft grip (Fig. 1).

2. While holding the three pieces together, install the four

(4) screws through the top clamp and into middle clamp.

NOTE: The holes in the top and middle clamp will line up

only when assembled correctly.

3. Place the clamps and the J-handle over the shaft

housing and onto the bottom clamp.

4. Hold each hex nut in the bottom clamp recess with a

finger. Start screws with a large Phillips screwdriver.
Do not tighten until you make the handle adjustment.

5. Slide the J-handle in or out until the arrow/white line on

the decal touches the clamp assembly (Fig. 3). You must
first loosen the screws if the handle is pre-installed.

Fig. 2

Fig. 3

6. While holding the unit in the operating position

(Fig. 27), position the J-handle to the location that
provides you the best grip.

7. Tighten the clamp screws evenly, until the J-handle

is secure.

INSTALL AND ADJUST THE J-HANDLE

1. Place the J-handle between the top and middle

clamp pieces (Fig. 2).

Decal

CC4090 ONLY:

INSTALL THE HARNESS

1. Push the strap through the center of the buckle.

2. Pull the strap over the cross bar and down through

the slot in the buckle (Fig. 4).

3. Put the harness on over head and onto shoulder.

Snap it on to the support fitting (Fig. 5).

4. Adjust length to fit the operator’s size. Pull tab to

lengthen, pull strap to shorten (Fig 6).

Support Fitting

Fig. 4

Fig. 5

Fig. 6

CC4090 ONLY:

REMOVE AND INSTALL

THE CUTTING ATTACHMENT SHIELD

Remove the cutting attachment shield when
using the unit as a brushcutter

Remove the cutting attachment shield from the shield
mount by removing the three (3) screws with a flat blade
screwdriver (Fig. 7). Store parts for future use.

The cutting
attachment shield

should NOT be installed when operating the
unit with a blade. Remove the cutting
attachment shield before removing or
installing the blade.

WARNING:

Always use the
shoulder harness

when using the cutting blade to avoid
serious personal injury.

WARNING:

(4) Screws

Top Clamp

J-Handle

Middle Clamp

Bottom Clamp

Nuts

Shaft

Housing

Bottom Clamp

Shaft Grip

Minimum 6 inches

(15.24 cm)

Fig. 1

Advertising
This manual is related to the following products: