MOOER Baby Tuner - Manual

1. TRUE BYPASS Footswitch:
Push down the footswitch to toggle
between on and true bypass status.
2. DC IN Power Jack:
For power supply, use a 9-volt
DC regulated AC adapter (plug
polarity is positive on the barrel
and negative in the center).
3. INPUT Jack:
1/4” mono audio jack, for connecting
guitar.
4. OUTPUT Jack:
1/4” mono audio jack, outputs the signal.
Main Features
Detection range: 12Hz ~ 4186Hz (C8)
Input: 1/4” monaural jack
Output: 1/4” monaural jack
Power Requirements: AC adapter 9V DC (center minus plug),
recommended to use Mooer Micro Power
Current Draw: 90 mA
Dimensions: 93.5mm (D) × 42mm (W) × 52mm (H)
Weight: 140g
Accessories: Owner’s Manual
* Disclaimer: Any specification’s update won't be amended in this manual.
A high precision tuning micro pedals, can be accurate to ±1 points
Works with most Electric or Electro-Acoustic instruments including
seven string guitar or five string bass
Display Uses 108 high brightness LED’s and is visible even in strong light/sun
Very small and compact design
True bypass switch
DC 9V adapter power supply
Tuner Pedal
5. NOTE Display:
Displays the note read with sharps in
upper right.
6. FINE TUNING Display:
The blue indicator light and the auxiliary
lights on both sides will show together
once tuning is correct.
Press the Baby Tuner ON/OFF switch to activate the tuner, the panel
light is lit up at this time, for the mute state
While tuning, "--" will show on when there is no signal input, but the
musical alphabet note indicator and fine-tuning indicator will shine
together once there is signal input
When correctly tuned, the blue middle indicator light and the red lights
on both sides will show on together
Note: When not tuning status, the signal is true bypass, screen doesn’t display
Operating instructions
4
3
6
1
5
PLEASE READ CAREFULLY BEFORE PROCEEDING
Power Supply
Connections
Always turn off the power of this and all other equipment before connecting or
disconnecting, this will help prevent malfunction and / or damage to other devices.
Also make sure to disconnect all connection cables and the power cord before
moving this unit.
Cleaning
Clean only with a soft, dry cloth. If necessary, slightly moisten the cloth.
Do not use abrasive cleanser, cleaning alcohol, paint thinners, wax, solvents,
cleaning fluids, or chemical-impregnated wiping cloths.
Interference with other electrical devices
Radios and televisions placed nearby may experience reception interference.
Operate this unit at a suitable distance from radios and televisions.
Location
To avoid deformation, discoloration, or other serious damage, do not expose
this unit to the following conditions:
Direct sunlight Heat sources
Magnetic fields Extreme temperature or humidity
Excessive dusty or dirty location High humidity or moisture
Strong vibrations or shocks
Please connect the designated AC adapter to an AC outlet of the correct voltage.
Please be sure to use only an AC adapter which supplies 9V (±10%) DC, center
minus. The maximum working voltage shall not exceed 12V, otherwise may be
dangerous equipment damage, fire or other problems.
Unplug the AC power adapter when not using or during electrical storms.
Precautions
FCC certification
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference
that may cause undesired operation.