MUTEC FMC-7 - Manual (Page 4)

\\\\\\\\\\\\\\
I N S TA LLAT I O N MAN UAL I N S TA LLAT I O N MAN UAL I N S TA LLAT I O N MAN UAL
> > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > >
> > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > 88
Manual Interfaces-01 D 23.1.2003 0:24 Uhr Seite 7
introduction
Thank you for purchasing the MUTEC FMC-05, FMC-06 or FMC-06 FlashROM
memory expansion for Yamaha Tyros 4 + 5, MOTIF XF 6-8 and MOXF6 + 8.
The FMC-05 expansion offers 512MB, the FMC-06 expansion 1024MB and
the FMC-07 expansion 2048MB storage capacity. After formatting, all
expansions can instantly be used in the respective device (note its manuals
for storing wav files imported from e.g. a USB sticks or a hard discs).
product Contents
Please check the contents of the package after the purchase of your
memory expansion for the following components:
1 x FMC-05, FMC-06 or FMC-07 FlashROM memory expansion
2 x spacers with M4 inside & outside threading, 8mm height
2 x screws with M4 threading
1 x installation guide (this document)
precautions
Before you install the FMC-05, FMC-06 or FMC-07 FlashROM expansion,
please read the passages »Precautions« and »Precautions for the instal-
lation« as well as »Warning« and »Caution« in the FlashROM installation
section of the instruction manual of your respective Yamaha device!
If any problems occur during the installation, instantly consult the dealer
you purchased this product from because MUTEC GmbH will not be liable
for any damage or consequential damage that arose out of unauthorized
intervention or installation!
installation of the FMC-05, FMC-06 or FMC-07 FlashROM
expansion
Please refer to the operation manual of your respective Yamaha device for
fundamental information about the installation of both expansions. You
find it in the appendix of the index under »Installing an optional Flash store
expansion module«. Yamaha marks the expansions as follows:
MUTEC FMC-05 = Yamaha FL512M
MUTEC FMC-06 = Yamaha FL1024M
MUTEC FMC-07 = not available from Yamaha
We furthermore refer to a special feature of the installation of your FMC-
05, FMC-06 or FMC-07 expansion card that was not mentioned in the
Yamaha manuals (see sketch below and continuation page):
Screw the two supplied spacers in the threaded bolts before you press
the FMC-05, FMC-06 or FMC-07 expansion into the connector socket on
the main board.
Caution!
the FMC-05, FMC-06 and FMC-07
Flash ROM expansions are equipped
with highly sensitive components. please
avoid any contact with them!
before the installation you should discharge
yourself at an unearthed device!
touch the expansions only at the edge of
the circuit board and avoid any contact with
its component connections!
!
FMC-05-, FMC-06-, FMC-07
FlashROM expansion
120pin connector socket
Threaded bolt
Threaded bolt
120pin connector socket
on the main board
(2)
(2)
(1) = supplied screws
(2) = supplied spacers
(1)
(1)
(Sketch partly taken from the Yamaha Tyros 4 manual)
Register your MUteC product
for Warranty and support!
We ask you to be so kind to register
your MUteC product through our website
immediately after purchasing. this ensures
full warranty services over a period of
two years after purchasing the product.
More-over, for all registered products we
offer free technical support. We also will
inform you about product updates and new
products which may of interest for you (on
voluntary base, of course).
please regsiter your MUteC product at:
www.mutec-net.com
> service > product Registration
thank you!
!