MUTEC MC-4 - Manual (Page 13)

> > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > 88
\
B E D I E N E L E M E N T E B E D I E N E L E M E N T E B E D I E N E L E M E N T E
> > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > >
Manual SDs-01 D 3.2.2003 17:45 Uhr Seite 3
13
Function Menus + Functions
Menus Functions
GENERAL OPERATION
Selecting Function Menus and setting Functions
The device is fully operated using the two toggle switches at the front
panel.
1 Switching the »MENU« button toggles between different basic function
menus.
2 Switching the »SELECT« button activtes individual functions within one
function menu.
Steps of Operation
1 First press on »MENU« or »SELECT« key enables the last selected function
within the last selected function menu. The corresponding LED is
beginning to flash.
2 Every press on »SELECT« button selects a new function within a menu.
The LED of the selected function flashs accordingly. After the LED stops
flashing, the function is activated.
3 When the needed function is selected, do not press the switches again!
After a period of approximately 4 seconds the LED of the selected
function stops flashing.
The »STATUS« and »CLOCK IN « areas are not accessible by using the
»MENU« and »SELECT« keys, because they only inform about different
conditions of incoming signals.
Safety Instructions
For safety reasons, be sure to
read the SAFETY INSTRUCTIONS
and INSTALLATION chapters before first
powering-up!
We also recommend reading the CONTROL
ELEMENTS AND TERMINALS chapter for
information on how to connect the device!
!
User Settings Remain
All user-specific function settings
are available furthermore when
power is restored.
!
Shut-Down of Outputs
All digital audio outputs are shut-
down during function selection!
After a function is finally selected and the
corresponding LED lights constantly again,
the digital audio outputs are activated for
signal transfer.
!
2. SELECT
Selects individual
functions within
one function
menu.
1. MENU
Selects individual
function menus.
MENU + SELECT operation