Quick start – Mytek Digital Stereo 192 Sample Rate Converter (ver. 1.2 / May 2011) User Manual
Page 5
Mytek Stereo 192 Sample Rate Converter – User Manual
Quick Start
1. Connect Digital Input and Output
Connect the output of your digital device to an input on the SRC.
Select this input on the front panel with the “
IN” button. A solid
LED will tell you that the source is valid. Connect the digital output
of the SRC to the digital receiving device.
2. Operation
You can choose to display either the input frequency or the
output frequency by pressing the “F-DISP” button. The unit
will convert the signal once a valid input and frequency is
selected.
3. Configuration
Using the “SEL” and “UP” buttons will allow you to cycle
through and select the various frequency options. Holding
down the “SEL” button until the first digit on the display
flashes will let you define a custom frequency with the “UP”
button to change the value and the “SEL” button to select the
next digit. Push “SEL” after the last digit to confirm your
value.
The “MODE” button cycles between Synchronous (SNC),
Asynchronous – Internal Crystal (ASNC-XTL), and
Asynchronous – External Wordclock (ASNC-WCK).
The “OUTPUT WORD LENGTH” button will select between
24, 20, or 16 bits output format. TPDF dithering is applied to
20 and 16 bits.
For user defined
frequencies less than
100,000 the left most digit
will be blank but it is still
cycled through with the
“SEL” button. The value
set won't be confirmed
until you push the “SEL”
button after the last digit.
Page: 5/12