Indesit IWDE 7145 K - Manual (Page 9)

GB
9
Wash cycles and options
Wash options
Selecting this option enables you to suitably adjust drum
rotation, temperature and water to a reduced load of lightly
soiled cotton and synthetic fabrics (refer to the “Table of
wash cycles”
). “ ” enables you to wash in less time
thereby saving water and electricity. We suggest using a
liquid detergent suitably measured out to the load quantity.
! This function may not be used in conjunction with cycles
1, 5, 6, 7, 8, 9, 10, 11, 12, 13, , , .
Intensive Wash
Because a greater quantity of water is used in the initial
phase of the cycle, and because of the increased cycle
duration, this function offers a high-performance wash.
! This function may not be used in conjunction with cycles
5, 6, 7, 8, 9, 10, 11, 12, 13, , , .
Easy iron
By selecting this function, the wash and spin cycles will be
modified in order to reduce the formation of creases. At
the end of the cycle the Washer-dryer will perform slow ro-
tations of the drum; the indicator lights for the EASY IRON
Table of wash cycles
and START/PAUSE options will flash (the first one green,
the second orange).
To end the cycle, press the START/PAUSE button or the
EASY IRON button.
For the 6 wash cycle, the machine will end the cycle while
the laundry is soaking and the EASY IRON and START/
PAUSE indicator lights will flash. To drain the water so that
the laundry may be removed, press the START/PAUSE
button or the EASY IRON button.
!
This function may not be used in conjunction with cycles
5, 8, 9, 10, 11, 12, 13, , .
Note: If you also want to run the drying cycle, this option is
enabled only if combined with level “A1” (Iron dry).
Delay Timer
To set a delayed start for the selected cycle, press the
corresponding button repeatedly until the required delay
period has been reached. When this option is enabled, the
corresponding indicator light will remain lit. To remove the
delayed start setting, press the button until the text “OFF”
appears on the display.
! This option can be used in conjunction with all cycles.
The length of cycle shown on the display or in this booklet is an estimation only and is calculated assuming standard working conditions. The actual duration can vary according to factors such as
water temperature and pressure, the amount of detergent used, the amount and type of load inserted, load balancing and any wash options selected.
For all Test Institutes:
1) Test wash cycle in compliance with regulation EN 50229: set wash cycle 1 with a temperature of 60°C.
2) Long wash cycle for cottons: set wash cycle 1 with a temperature of 40°C.
3) Short wash cycle for cottons: set wash cycle 3 with a temperature of 40°C.
W
ash cycles
Description of the wash cycle
Max.
temp.
(°C)
Max.
speed
(rpm)
Drying
Detergents Max. load (kg)
Cycle
duration
Wash
Fabric
softener
Normal
Eco
Time
Daily
1 White Cotton: extremely soiled whites. 90° 1400    7 -
1 White Cotton (1): heavily soiled whites and resistant colours. 60° 1400    7 -
1 White Cotton (2): lightly soiled whites and delicate colours. 40° 1400    7 -
2 Cotton: heavily soiled whites and resistant colours. 60° 1400    7 3,5
3 Coloured Cotton (3): lightly soiled whites and delicate colours. 40° 1400    7 3,5
4 Synthetics: heavily soiled resistant colours. 50° 800    3 2
Special
5 Wool: for wool, cashmere, etc. 40° 600 -   1,5 -
6 Silk/Curtains: for garments in silk and viscose, lingerie. 30° 0 -   1 -
7 Jeans 40° 800    3 -
Sport
8 Sport Intensive 30° 600 -   3 -
9 Sport Light 30° 600 -   3 -
10 Special Shoes 30° 600 -  
Max. 2
pairs
-
Dry
11 Cotton - -  - - 5 -
12 Synthetics - -  - - 3 -
13 Express Wash&Dry 30° 1400    0,5 -
Partial wash cycles
Rinse
- 1400  -  7 -
Spin - 1400  - - 7 -
Drain - 0 - - - 7 -
The duration of the wash cycles can be checked on the display
.