Cub Cadet 8454 - Manual (Page 19)

19
• Using Mixed Control — In draft control, when draft
decreases, the implement automatically lowers to
increase draft. However, the implement some-
times lowers too much. To limit the degree the
implement can be lowered, set the position control
lever at the lowest working depth desired for the
implement; then lower the draft control lever to the
point where the implement is at the desired depth.
This stops the implement from going too deep and
also controls the pull to prevent loss of traction and
ground speed.
Brake Pedal Lock
The brake pedal lock is located on the right brake
pedal. Flip the lock counterclockwise so it engages
the bracket on the left brake pedal to interlock both
brake pedals. See Figure 18.
Figure 18
Seat Adjustment Lever
The seat adjustment lever is located beneath the left
side of the seat. This lever is used to adjust the seat
forward or backward to the desired operating position.
See Figure 19.
Figure 19
PTO Safety Switch
Located on the right fender. To stop the PTO in an
emergency, depress the switch. The switch must be
pressed a second time (switch button in the up
position) to re-engage the PTO. See Figure 20.
Figure 20
BRAKE
PEDAL
LOCK
Engage
Disengage
SEAT ADJUSTMENT LEVER
OFF
ON
- On
- Off
PTO
SAFETY
SWITCH