NM Engineering 228856 - Manual

NM Engineering ∞ 3300 Corte Malpaso, Camarillo, CA 93012 ∞ 805.388.7171 ∞ 805.388.0030 FAX
engineer@nm- eng.com ∞ www.nm-eng.com
PARTS INCLUDED:
TOOLS REQUIRED:
[2] NM Urethane Inserts [1] Torque Wrench [1] Ratchet Wrench [1] 16mm Socket
[1] Insert Support Bracket [1] Jack [2] Jack Stands
1. Park car on a flat and level surface capable of supporting
the vehicle’s weight on vehicle jack and jack stands. Using
the manufacturer recommended lifting points, raise the
front of vehicle and support with jack stands under lifting
points. NEVER WORK ON A VEHICLE SUPPORTED
ONLY WITH A JACK!
2. Underneath the vehicle: Unbolt the [2] 16mm hex bolts to
remove the engine torque arm.
3. Install NM Engine Torque Arm Insert into each side of OE
torque arm. NOTE: Red urethane used for picture clarity.
4. Install Torque Arm, supplied Support Bracket and torque
bolts to 80 foot/pounds (108nm). Double check installation.
ENGINE TORQUE ARM INSERT
– NM.228856
[R55] MINI Cooper S & non-S Clubman 2008-up
[R56] MINI Cooper S & non-S Hardtop 2008-up
[R57] MINI Cooper S & non-S Convertible 2009-up
©2008 NM Engineering, a division of Automotive Performance Systems, Inc.
All rights reserved. Reproduction in whole or in part is prohibited.
DOC. NM.228856 Rev. 04.24.12