NORAC UC4.5-BC-EU1 - Manual (Page 25)

22
5. Connect the 12-pin and 6-pin Deutsch plugs (P12 and P6B) of the power cable (C10) to
R12 and R6 of C11 on the outside of the cab.
For a pull type sprayer, connect at the hitch. This connection will provide the
hitch disconnect.
6. Route C11 to the vicinity of the valve block at the rear of the sprayer.
7.1 Electrically Teed Installation
Figure 25: Cable Layout for Electrically Teed Installations
1. It may be necessary to connect to the Bypass valve. To do this use the bypass interface
cable (C13) as shown in Figure 25.
2. To control boom slant (roll), it will be necessary to use the roll cable (C16).
See UC4.5-BC-CABLE-GUIDE cable ordering guide for more information.