2 valve block mounting – NORAC UC4.5-BC-FC2 User Manual
Page 22
Advertising
19
8.2 Valve Block Mounting
Ensure that no hydraulic components will interfere with any sprayer parts or be
pulled tight at any time.
1. A suitable mounting location for the valve block is illustrated in Figure 19.
2. Insert the threaded rod into the block and use a hex nut to hold the rod. The block holes
are 3/8” NC-1” deep. If bolts are used instead of the threaded rod, ensure the bolts thread
in at least 3/8”.
3. Use the remaining hardware to secure the block to the sprayer.
4. Cut off excess threaded rod, if necessary.
Figure 19: Valve Block Mounting
Advertising