NORAC UC4.5-BC-FT1 User Manual
Page 24
21
6. For optimal performance of the UC4.5 system, there should be very little play at the hitch
clevis. The addition of polymer washers can help tighten up this connection (Figure 19).
Figure 19: Hitch Point
7. The procedure for the installation of the UC4.5 Spray Height Control system is now
complete.
8. Turn on the power for the UC4.5 Control Panel using the switch on the side of its chassis.
If “FT1” shows up as the sprayer type, start the “ReTune” process as described in the
UC4.5 Spray Height Control Operator’s Manual (M01). This will tune the UC4.5 hydraulic
parameters to the tractor hydraulic system.
9. If no type is selected yet, begin the AUTOMATIC SYSTEM SETUP procedure as described
in the UC4.5 Spray Height Control Operator’s Manual (M01).