NORAC UC4+BC+GV1 - Manual (Page 25)

23
Figure 27: Cable Configurations: C11, C09 and C10
2. Connect the 16-pin AMP plug on the
power cable (C10) to the UC4+
Control Panel (E01) in the sprayer cab.
3. Connect the power cable (C09) to the
3 pin AMP connector on C10. Cable
C09 can be connected in line with the
Raven power connection in the sprayer
cab (Figure 27). The Raven power
connection is a 3 pin Weatherpack
connector located in the front right
hand console. To access it the front
plate will have to be removed.
Figure 28: Console Access
4. Route the longest connector on cable
C10 out the rear of the cab.
5. Connect the 16 pin AMP connector on
cable C11 to the 16 pin AMP connector
on C10.
Front of Sprayer
Console
Access