NORAC UC5-BC-GN02 - Manual (Page 17)

14
8 Connecting the Sensors to the CANbus
1. Route cable C03 from the input module to the 3-way coupler (E10).
2. Fasten the 3-way coupler to the boom with cable ties.
3. Connect two cables (C05) to the 3-way coupler and route along the booms to the wing
sensors. Follow existing cables and hoses to be sure the cable will not be pinched or
stretched.
Figure 12: UC5 Module Locations and Cable Connections
4. At the sensor brackets, attach a 2-way coupler with terminator (E20) to the sprayer boom.
The 2-way coupler with terminator is the white two way coupler. Plug the sensor and the
CANbus cable into the 2-way coupler.
Ensure that all unused connectors are plugged with the plugs provided.