NORAC UC5-BC-HD06 - Manual (Page 30)

27
* Note that on some sprayers the slant valve wiring varies from machine to
machine. This applies to all machines.
 If the left-hand tip lifts when the left button is pressed and the right-hand button lifts the
right hand tip (as shown in Figure 28), the wiring as described above is correct.
Figure 28: Default Slant Direction Wiring
 However, if the boom does the opposite of what is described above, it is necessary to swap
the wires in positions 2 & 5 in the P12B connector of 43240-30 (C20). P12B is the 12-pin
connector that is connected to the Thru 1 connector of the in[ut module. Remove the
wedge from the face of the connector by inserting a small flat implement underneath the
wedge and lifting it up. Insert the wedge back into the plug when finished.