NORAC UC5-SM03-4B - Manual (Page 13)

10
6 Electrical Installation
1. Locate the valve module installed on the NORAC valve block.
2. Remove the plugs installed in positions 5 and 6.
3. Connect the 2 pin connector on cables C10 into positions 5 and 6 on the valve module.
4. Connect the other end of cables C10 to the 2 pin connectors on the NORAC expansion
block (V01).
5. Remove the existing cable C03 from the existing input module. Connect the unplugged
connector from existing cable C03 into the 3-way coupler (E10).
6. Connect one end of cable C03 to the existing input module and the other end to the 3-way
coupler (E10).
7. Connect one end of cable C04 to the 2-way coupler (E12) and the other end to the 3-way
coupler (E10).
8. Connect the cable from the Roll Sensor (E04) to the other end of the 2-way coupler (E12).
Figure 7: Valve Module Connections
Output Number Normal Function
1 Left Up
2 Left Down
3 Right Up
4 Right Down
5 Main Up
6 Main Down
7 Option 3
8 Option 4