NORAC 5467BC-JD - Manual (Page 6)

3
4. Mount the brackets (B09) as shown in Figure 3, Figure 4 and Figure 5. Install two (2)
cable ties per bracket.
Figure 3: Bottom Bracket Mounting Figure 4: Top Bracket Mounting
Figure 5: Bracket Mounting (Looking from the Rear)
5. Install the base end of the position sensor with the cable facing the center of the sprayer in
the lowest hole of the bracket possible without making contact with the boom frame. Use
the mounting hardware as shown in Figure 6.
Figure 6: Mounting Hardware
6. Install the linear sensor mounting bolt in the hole of the upper bracket that closest aligns
the end of the sleeve with the center of travel mark (black mark) on the sensor (Figure 7).
If the mark is missing, the distance from the end of the sleeve to the top of the base should
Collar Bolt Nut Nut