NOYAFA NF-388 - Manual (Page 10)

Test Result 4: Wiring diagram (WIREMAP) display
when there is an open circuit at the far-end of cable.
Wire map:fail
R: 12 x45 x78 id1
Iiiiiiii
M: 12345678
" R:" line "3" and "6" pins location display "x", it indicates an open circuit
infar-end plug "3" and "6" pins and the open circuit is located nearby the
far-end plug.(The open point should be at the 10% cable length)
Note:
the detected cable is made of paired cable cores, “open”
error at the far-end always displays in pair as above.,which means there
is one open circuit or both
because
are open in the far-end"3"and "6"pins.
Test Result 5: Wiring diagram (WIREMAP) display when
there is an open circuit at the near-end of cable.
It will display wiring diagram (WIREMAP) as follows if there is an open
circuit at the near-end plug of the cable:
Wire map:fail
R: 12345678 id1
Iiiiiiii
M: 12 x45678
" M:" line "3" pin location displays "x", it indicates an open circuit at
near-end plug "3" pin and the open circuit is located nearby the near-
end plug.(The open circuit should be located within 10% cable length
if it is measured from the near-end plug)
Test Result 6: Wiring diagram (WIREMAP) display when
there is an open circuit in the middle of the cable.
It will display wiring diagram (WIREMAP) as follows if there is an
opencircuit in the middle of the cable:
Wire map:fail
R: 12345678 id1
Iixiiiii
M: 12345678
"|" line "3" pin location displays "x", it indicates an open circuit in the
middle of "3" pin cable. (The open circuit should be located within
10%-90% cable length if it is measured from the near-end plug.) as
detailed hereinafter.
Your excellent helper in cable test! 07