NOYAFA NF-868 - Manual (Page 10)

M:
R:
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
d. Crosstalk test
As shown the figure below: it shows 3, 6 and 4, 5 with crosstalk. The line
pair with crosstalk will flash to indicate failure. In the line pair with crosstalk,
end-to-end connection is correct. However the connected lines are from
different line pairs. Line pair crosstalk will cause an over large crosstalk,
otherwise network speed will be slow.
3
4
5
6
3
4
5
6
Connection diagram of crosstalk line pair
Crosstalk interface is shown as below:
Crosstalk line pair flashes
Note: In case of the non-twisted-pair cable like telephone cable,
due to over large crosstalk, it generally shown as crosstalk.
Wire Map: Remote
15
Type: PAIR(8)
U n i t : M e t e r
C a l i b r a t i o n
L o a d D a t a
Calibration and setup
Type selection:
1). Type: twisted-pair cable
When testing network cable, users need to firstly choose”Pair(8)” in”Type”
after this, users can test cable length and check its wiremap.
2). Type: telephone cable
When testing telephone cable, users need to firstly choose”Tel(6)” in”Type”
after this, users can test cable length and check its wiremap.
16
After powering the main tester and entering the main test menu, press “UP”,
“DOWN” key to move cursor “ ” to “Configure” , and then press “ENTER”
key to perform calibration and setup function. The following
interface will be shown:
语 言: 中 文
对 线 测 试
长 度 测 试
寻 线 测 试 Lang: English
Wire Mapping
Cable Length
Scan Cable Lang: English
Choose the Language, Chinese or English
then you can get the screen as you desired.
Your excellent helper in cable test! Your excellent helper in cable test!