NOYAFA NF-268 - Manual (Page 5)

2.1 Cable tracing
2.1.1)Open battery cover, install DC 9V battery in launcher,push the
key of emitter to “scan”, the indicator flashes, which means the emitter
is normal.
2.1.2)Connect the cable to be tested to corresponding port.
2 . 1 . 3 )P u s h t h e k e y o f r e c e i v e r t o “ S c a n ” , t h e i n d i c a t o r f l a s h e s ,
which means the emitter is normal. Then hold the receiver to trace
cable.
During operation, users can alter the volume gradually to ideal state.
Attention:
1)If the cable to be traced is energized (＜60VDC) , users have to turn
the volume to degree 1-3.
2)If the cable to be traced is non-energized, users have to turn the
volume to degree 6-8.
2.2 Cable mapping
2.2.1)Connect network line to the RJ45 port of emitter and receiver
separately.
2.2.2)Push the key of receiver to “Test”, the indicator flashes, which
means
the emitter is normal. then go ahead with the test result.
(Note: users can press”SET” to choose the testing speed)
2.2.3)When the tested cable is in good connection,
If UTP cable, No.1-8 leds will blink one by one in circulation.
Emitter: 1-2-3-4-5-6-7-8
Receiver:1-2-3-4-5-6-7-8
If STP cable, No. 1-8 &G leds will blink one by one in circulation.
Emitter: 1-2-3-4-5-6-7-8-G
Receiver:1-2-3-4-5-6-7-8-G
2.2.4)When the tested cable is not connected well
If No. 2 & No.3 cables are shorted, the No.2 & 3 Leds of receiver won’t
be on, while No.1-8 leds of emitter is still on in circulation.
If No.2 cable is open, the No.2 led of emitter and receiver won’t be on.
2.Operations
Your excellent helper in cable test! 2