O.S. Engines 21XZ-M - Manual (Page 3)

4
This engine was designed for model boats.
Do not attempt to use it for any other purpose.
Mount the engine in your model securely,
following the manufacturers' recommenda-
tions, using appropriate screws and lock-
nuts.
Install an effective silencer (muffler).
Frequent close exposure to a noisy exhaust
(especially in the case of the most powerful
high-speed engines) may eventually impair
your hearing and such noise is also likely to
cause annoyance to others over a wide area.
Take care that the glowplug clip or battery
leads do not come into contact with the pro-
peller or any other rotating parts. Also check
that the linkage to the throttle arm is secure.
If your engine does not have a built-in recoil
starter, use an electric starter. The wearing of
safety glasses is also strongly recommended.
When handling the boat immediately prior to
launching, be especially cautious.
Keep the propeller and other rotating parts
away from you.
NOTES
For their safety, keep all onlookers
(especially small children) well back (at
least 20 feet or 6 meters) when preparing
your model for running.
Before starting the engine, always check the
tightness of all the screws and nuts especial-
ly those of joint and movable parts such as
throttle arm. Missing retightening the loose
screws and nuts often causes the parts
breakage that is capable of harming you.
5
Adjust the throttle linkage so that the
engine stops when the throttle stick and
trim lever on the transmitter are fully
retarded. Alternatively, the engine may be
stopped by cutting off the fuel supply.
Never try to stop the engine physically.
Warning! Immediately after a glowplug-
ignition engine has been run and is still
warm, conditions sometimes exist whereby
it is just possible for the engine to abruptly
restart if it is rotated over compression
WITHOUT the glowplug battery being
reconnected.
NOTES