Tools and accessories introduction – O.S. Engines FF-320 User Manual

Page 3

Advertising
background image

4

Take care that the glow plug clip or battery leads do not come into contact with the propeller.
Also check the linkage to the throttle arm. A disconnected linkage could also foul the propeller.

After starting the engine, carry out any needle-valve readjustments from a safe position behind the rotating
propeller. Stop the engine before attempting to make other adjustments to the carburetor.

Adjust the throttle linkage so that the engine stops when the throttle stick and trim lever on the transmitter are fully
retarded. Alternatively, the engine may be stopped by cutting off the fuel supply. Never try to stop the engine
physically.

Take care that loose clothing (ties, shirt sleeves, scarves, etc.) do not come into contact with the propeller.
Do not carry loose objects (such as pencils, screwdrivers, etc.) in a shirt pocket from where they could fall through
the propeller arc.

Do not start your engine in an area containing loose gravel or sand. The propeller may throw such material in your
face and eyes and cause injury.

For their safety, keep all onlookers (especially small children) well back (at least 20 feet or 6 meters) when preparing
your model for flight. If you have to carry the model to the take-off point with the engine running, be especially
cautious. Keep the propeller pointed away from you and walk well clear of spectators.

Warning! Immediately after a glowplug-ignition engine has been run and is still warm, conditions sometimes exist
whereby it is just possible for the engine to abruptly restart if the propeller is casually flipped over compression
WITHOUT the glowplug battery being reconnected. Remember this if you wish to avoid the risk of a painfully rapped
knuckle!

Use an electric starter for this engine. The wearing of safety glasses is also strongly recommended.

5

The O.S. FF-320 (PEGASUS320) is a horizontally-

opposed four-cylinder overhead-valve four-stroke-

cycle engine of 53.04cc (3.24cu.in) displacement.

The horizontally-opposed layout, typical of modern

light aircraft engine design, provides very smooth

running qualities and docile, trouble-free handling

characteristics.

TOOLS AND ACCESSORIES

INTRODUCTION

The following tools and accessories are supplied with your
engine.

1

4

4

4

4

4

1

Description

Quantity

No.

1

2

3

4

4-1

4-2

Radial Motor Mount Set

Radial Motor Mount(installed on the engine)

Mount attachment Screws

Engine mounting screws (M5X25)

Lock washers (ø5)

Blind nuts (M5)

Set of leads for wiring glow plugs:

Leads for glow plug with clip

Lead for earth (ground)

Woodruff key

Valve adjusting tool kit

Hexagonal (Allen) key (4mm)

Choke valve rod

Drain plug

Description

Quantity

No.

5

6

7

8

9

1

1

1

1

1

Photo 1

Advertising