O.S. Engines FS-40S - Manual (Page 28)

VALVE ADJUSTING
ALL O.S. four-stroke engines have their valve(tappet)
clearances correctly set before they leave the factory.
However, if, after many hours of running time have
been logged, a loss of power is detected, or if the
engine has to be disassembled or repaired as a result
of an accident, valve clearances should be checked
and readjusted, as necessary an O.S. Valve Adjusting
Tool Kit is available as an optional accessory.
• Feeler gauge 0.04mm
The kit comes in a plastic case and includes:
(Code No.72200060)
• Feeler gauge 0.1mm
• Hex. key 1.5mm
• Wrench 5mm
Note:
Valve clearances of all O.S. four-stroke-cycle
engines must be checked and reset ONLY WHEN
THE ENGINE IS COLD.
Procedure is as follows:
Remove the cover from the rocker-box on top of the
cylinderhead, using the correct size Allen hex key. 1.
( 1 )
Turn the propeller counter-clockwise until
compression is first felt, then turn it futher quarter
turn. At this point, both valves should be closed. (If
the prop driver ('drive hub') of your engine is
engraved with a letter 'T', this mark should now be
at the top.) 2.
The standard valve clearance, on both inlet and
exhaust valves, is between 0.04mm and
0.10mm(0.0015-0.004 inch), measured between
valve stem and rocker arm. Use the 0.04mm and
0.10mm feeler gauges to check clearances.
(See Fig.1.) 3.
27