O.S. Engines FS-26S-CX User Manual
Page 15
1.5mm
■
Turn the needle-valve gently clockwise until it
stops. Do not use force to turn the needle
beyond this point. Now reopen it 2 turns.
Set the throttle-stop screw
so that the minimum
throttle opening (idle
setting) is approximately
1.5mm.
Switch on the transmitter, followed by the
receiver. Close the throttle stick and open the
throttle trim lever to the idle setting.
Connect the glowplug battery and apply the
electric starter. As soon as the engine starts,
disconnect the glowplug battery, keeping the
engine running slowly on the rich needle set-
ting. (If necessary, make a slight readjustment
to the throttle stick to keep the engine idling
steadily.) If the engine stops, allow it to cool for
a minute or two before restarting it. In fact, short
runs, interrupted by brief cooling-off periods is
good practice during running-in.
Front
Rear
Rotating Direction
●
●
●
●
Starter Handle
When the FS-26S-CX is installed in certain
ready-to-run cars:
Press choke button on car's fuel tank
sufficient to prime carburetor.
(Do not overprime!)
●
Making sure that
glowplug remains
switched off, check
that starter handle can
be pulled out, then re-
connect plug and
operate starter briskly
until engine starts.
●
14