O.S. Engines FS-26S-C II - Manual (Page 7)

12
Install the insulator and intake manifold on
the cylinder head.
INSTALLATION OF THE CARBURETOR & HYPER EXHAUST GASKET
Note:
Installation procedure may vary according
to the car kit.
Insulator
Hyper Exhaust Gasket
Carburetor
Retainer
Intake Manifold
Carburetor Gasket
Lock Nut
Fuel Inlet
Needle Holder
Install the carburetor retainer nut on the
intake manifold temporarily.
Install the carburetor gasket on the
carburetor.
Press the carburetor into the exhaust
manifold and fasten the lock nut gradually
until it stops.
Fasten the lock nut a further 60-90 degrees.
Do not fasten any further or the parts will be
distorted and/or damaged.
If you wish to change the fuel inlet position,
loosen the needle holder and set the inlet at
desired position, then fasten the needle
holder gradually until it stops and fasten a
further 45-60 degrees. Do not fasten any
further or the inlet will be distorted, which
results in fuel leaking.
Insert Hyper exhaust gasket into the exhaust
port.
13
ENGINE INSTALLATION
Make sure that the vehicle's engine mounting
surfaces are level and in the same plane. Poor
installation may cause distortion of the
crankcase, bearings, etc., resulting in erratic
running and loss of performance. The
recommended screws for securing the engine
are 3mm or 4-40 steel Allen hexagon socket
type. If existing holes in the engine mount do not
align perfectly with engine mounting lugs,
enlarge them slightly with a needle-file so that
screws enter vertically. Avoid forcing the screws.
Secure with locknuts.
Chassis
Chamfer inside edges of bearers.
Chassis