Casio KL-C500 - Manual (Page 48)

E-47
Name being assigned
to a barcode is already
used.
Tape cartridge is not
compatible with label
printer model.
Attempt to input a 16th
block mark (only 15 are
allowed).
Too many lines for
printing with a frame.
Printing operation per-
formed while the tape
cartridge compartment
is empty.
Message Possible Cause Action Page
Use a different name.
Turn off power and
load the proper tape
cartridge.
Delete block marks
you don’t need.
Reduce the number of
lines or use a wider
tape.
Load a tape cartridge
and try again.
THAT NAME IS
ALREADY
USED!
THIS IS THE
WRONG TYPE
OF TAPE
CARTRIDGE
TOO MANY
BLOCKS!
TOO MANY
LINES
TO FRAME!
TURN OFF
POWER THEN
LOAD A TAPE
CARTRIDGE
E-35
E-8
E-25
E-13
E-21
E-8
PRINTING
ERROR!
CHECK THE
TAPE CAR-
TRIDGE!
RESET THE
LABEL
PRINTER!
SAME DATA
ALREADY
EXISTS!
SEND ERROR!
•
Tape jam during
printing
•
Some foreign object
in the tape cutter
• Some foreign object
or tape residue on
the rubber roller
Memory has not been
initialized yet.
Attempt made to store
data when the same
data already exists in
memory.
•
You did not perform
sending the data
within 20 seconds af-
ter the “RECEIVE
OK!” message ap-
peared.
•
Label printer was un-
able to receive data
being sent from an
external source.
•
Tape cartridge type is
not suitable for the
type of data being
sent to the label
printer.
•
Interruption of data
send from the com-
puter
Message Possible Cause Action Page
•
Turn off power, re-
move the tape car-
tridge, and clear the
tape jam.
•
Turn off power, re-
move the tape car-
tridge, and remove
the foreign object.
• Clean the rubber
roller to remove the
foreign object.
Perform the reset op-
eration.
Store other data.
•
Press any key be-
sides ON, FUNC-
TION, SHIFT or
CODE and start
again.
•
Check cable connec-
tions and parameter
settings.
•
Turn off power and
replace the tape car-
tridge. Load a single-
colored tape for
monochrome data or
a colored tape for
color image data.
•
Try again.
E-8
E-9
E-39
E-8
E-36
E-38