OmniSistem WiDMX Transceiver - Manual (Page 21)

F
With MODE key (Fig.51) find the text like in (Fig.52).
To change the receiver band hold SET key (Fig.53) until the value
changes (Fig.54).
Slow blinking: Receiver O OK K, no D DM MX X 5 51 12 2 signal.
Fast blinking: Channel research.
Switched on : Receiver O
OK K, D DM MX X 5 51 12 2 signal O OK K.
N N..B B.: If a Radio channel between 0 0R R a an nd d 9 9R R is used, the led is R Re ed d.
If a Radio channel between 0 0G G a an nd d 9 9G G is used, the led is G Grre ee en n.
This function allows to visualize the state of the receiver and to change the
receiver band.
6.4 SETTING OF RX2
6.5 LED 2 FUNCTION
Fig. 51
rX2
:
128ch C
:
0g
Fig. 52
rX2
:
128ch C
:
0r
Fig. 54
rX2
:
no data C
:
0g
Fig. 52
rX2
:
searching...
Fig. 52
MODE
Reception OK
Reception OK
no DMX signal
Radio channel research
Radio band changed
SET
Fig. 53
This function allows to pair the receiver Wi D Pen to the TX1 of the Extender
Wi DMX.
Follow the instructions at (v.par.4.6)
6.6 RECEIVER PAIRING
This function allows to pair the RX2 of the Extender Wi DMX with a Wi DMX
set as trasmitter.
Follow the instructions at (v.par.5.6)
6.7 PAIRING WITH TRANSMITTER (GET PAIRING)
This function allows to pair the RX2 of the Extender Wi DMX with a Wi DMX
set as trasmitter using Wi D PEN.
Follow the instructions at (v.par.5.7)
6.8 PAIRING WITH TRANSMITTER (GET PAIRING) USING WI D PEN