Chaparral Fibre Channel -to-SCSI Router Chaparral FS 1310 - Manual (Page 37)

Configuring the Router
3-9
To change the Loop ID:
1 From the System Menu, select Configuration Menu and press Enter.
The Configuration Menu screen displays.
2 Select Host Configuration and press Enter.
The Host Configuration screen displays.
3 Select the topology you want and press Enter, or press Enter if the correct topology
is already selected.
The current setting is marked with an * next to it. For information about the topology
selection, see
Selecting the Topology on page 3-7 .
The Loop ID screen displays if Loop Topology was selected.
4 Select the option or number you want to use and press Enter.
The Router LUN screen displays. The text inside the parenthesis ( ) shows the current
Router LUN.
To Do this
Let the FC loop initialization process
determine the Loop ID each time the
router powers up
!
Select SOFT and press Enter.
This is the default setting
Keep the same Loop ID for the router
at all times
!
Select the [Loop ID] you want to use
and press Enter.
This can be any number from 0 to 125.
Note: See Appendix A, Address and Device Mapping for more details on
how the value selected for the Loop ID will correspond to the AL_PA.