OmniSistem OnyxPro 132 - Manual (Page 18)

Chase 1 ~ 8 Chase 3
Edit Chase ② Chase 1 Chase Test
… Step 01 =SCXXX
Chase 8 Step 64 =SCXXX Test
Beginning Scene
Ending Scene
Edit Scenes ② Edit Scene 001 Pan, Tilt… =XXX
~ Edit Scene Fade Time =XXX
250 Scene =XXX
Time
DMX Input Input Manual Scene
Fading Time
Scene Time
Input Scene from
Controller
Scenes Record ScXX=>ScXX Auto Input Scenes
Connect
DMX Address Setting
With this function you can adjust the desired DMX address via the Control Board.
Select “DMX Address“ by pressing Up or Down.
Press the Enter button then adjust the DMX address by pressing Up or Down.
Press the Enter button to confirm.
Light
Max Temperature
With this function you can set the inside temperature at which the projector will automatically switch the lamp
off. Press Up or Down to select the maximum internal temperature between 80°C and 139°C. Internal
temperatures below 90°C are not critical. 90°C and more should lead to the lamp being switched off after five
minutes. Please note that the outside temperature should not exceed 45°C.
Information
Current Time Information
With this function you can display the temporary running time of the device from the last power on. The display
shows “XXXX”, “X“ stands for the number of hours. The counter is reset after turning the device off.
Fixture Life
With this function you can display the running time of the device. The display shows “XXXX”, “X“ stands for the
number of hours.
Temperature Near Lamp Temp
With this function you can display the temperature in the projector head in degrees Celsius/Fahrenheit.
Fan speed
With this function you can display the current fan speed. The display shows “XXXX”, “X“ stands for Hz.
Initial status
With this function you can display which value the respective channels will start.
Error channels
With this function you can display the channel errors.
Fixture Model
With this function you can display the model number and brand of the fixture.
Software version
With this function you can display the software version of each IC.
1. Select “Software ver.” by pressing Up or Down.
18 of 26