OmniSistem PR Solo 1200 - Manual (Page 9)

SOLO 1200 EN.doc 9/18
Lock Tilt.
Loosen 4 screws of the front cover, you will see rotated gobo wheel and fixed gobo wheel.
(As shown in the above figure.)
For gobos replacement on the rotated gobo wheel: take an appropriate tool to tug up spring and take
out the rotating gobo with its holder; tug the head of retaining spring up and engage your another
hand to take the retaining spring out; take the gobo out; fit a new gobo and fit the retaining spring; fit
the holder. Notes: the gobo cannot be touched with bare hand; be careful of the gobo when the
replacement is underway and don’t drop it.
For gobos replacement on the fixed gobo wheel: turn the rotated gobo wheel to a proper position first;
take out a gobo from the fixed gobo wheel carefully; fit a new gobo. Note: if the gobo is a glass one, it
should be touched with glabrous, clean and soft tissue or cloth matted between hand and glass
instead of with bare hand.
Close the front cover with 4 screws and fasten 2 latch catches.
Pan’s belts
Free 2 screws on Pan assembly’s maintenance
door and open the door; change the belts;
close the door and fasten the screws.
Tilt’s belts
The common users replacing the belts is not
recommended.
White.Note: stay 5 seconds while DMX value is 5, 6or 7, the function reset perform
REPLACING GOBOS
CHANGING BELTS
Screws
Base
Open the door